5 Practical Ways to Install Roof Flashing

Installing roof flashing requires special skills so you may need professional help. To better understand it, let's look at the following steps to install flashing along the edge of the roof.

1. Prepare Tools and Materials

Before starting the flashing installation, you must prepare all the necessary tools and materials. Some tools that need to be prepared, such as a meter, drill, light steel scissors, hammer, roofing screws, sealant and additional materials such as underlayment and shingles.

2. Ensure the Roof is Installed Precisely

Make sure the roof is installed precisely. This step is very important to ensure that the flashing is installed correctly at the top of the roof to prevent leaks in the corner area of ​​the wall.

3. Cleaning the Roof

Next, make sure the roof is clean. This is because dust, dirt, and debris that accumulates can interfere with the installation of flashing and reduce the effectiveness of the sealant. Use a broom and soft brush to clean the roof from dust and dirt.

4. Installing Flashing Along the Edge of the Roof

Start installing flashing along the entire edge of your roof. Place the flashing carefully, making sure the top is against the wall and the bottom is covering the edge of the roof. Then nail the flashing to the edge of the wall.

5. Ensure Flashing is Installed Properly

After all the flashing is installed, the last step that must not be missed is to ensure the flashing is installed precisely. You need to double check all screw connections and make sure there are no gaps or unprotected areas.

The final inspection is very important to ensure the flashing is installed neatly and is able to provide optimal protection for your home. Hopefully useful.